Xbox Series X Back Panel Replacement

Introduction

Use this guide to remove or replace the back panel on an Xbox Series X.

Before you begin, completely power down and unplug all cables from your console. Remember to follow general electrostatic discharge (ESD) safety procedures while repairing your console.

What you need

Step 1 Uncover the back panel screws

Xbox Series X Back Panel Replacement, Uncover the back panel screws: step 1, image 1 of 2

Xbox Series X Back Panel Replacement, Uncover the back panel screws: step 1, image 2 of 2

Before you begin, completely power down and unplug all cables from your console.
Use a pair of tweezers to remove the sticker hiding the first screw on the back panel, near the base.

Edit

Step 2

Xbox Series X Back Panel Replacement: step 2, image 3 of 3

For cleaner removal, use an iOpener or hair dryer to heat the sticker.
Use a pair of blunt tweezers to peel back the large sticker on the back panel to reveal the second screw.
You only need to peel this sticker to where you can access the hidden screw. You don't need to pull it completely off.
Technically, these are tamper-evident stickers, but don't worry—Microsoft can't legally void your warranty, as long as you don't damage anything. Have fun!

Edit

Step 3 Remove the back panel screws

Xbox Series X Back Panel Replacement, Remove the back panel screws: step 3, image 1 of 1

Tool used on this step:

Magnetic Project Mat

€19.95

Buy

Use a T8 Torx driver to remove the two 7.4 mm‑long screws securing the back panel.
Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your console.

Edit

Step 4 Unclip the back panel

Xbox Series X Back Panel Replacement, Unclip the back panel: step 4, image 1 of 3

Xbox Series X Back Panel Replacement, Unclip the back panel: step 4, image 2 of 3

Xbox Series X Back Panel Replacement, Unclip the back panel: step 4, image 3 of 3

Insert the flat end of a spudger into the gap between the back panel and the shell, near the left side of the base.
Pry up the back panel to release it from the locking clips.

Edit

Step 5

Insert the flat end of a spudger into the gap between the back panel and the shell, near the right side of the base.
Pry up the back panel to release it from the locking clips.

Edit

Step 6 Remove the back panel

Xbox Series X Back Panel Replacement, Remove the back panel: step 6, image 1 of 3

Xbox Series X Back Panel Replacement, Remove the back panel: step 6, image 2 of 3

Xbox Series X Back Panel Replacement, Remove the back panel: step 6, image 3 of 3

Grip the back panel at the opening you just created and pull it up and away from the shell to unclip the long edges.
During reassembly, press along the edges of the back panel to snap it into place.

Edit

Step 7

Xbox Series X Back Panel Replacement: step 7, image 3 of 3

The back panel slots into a gap at the top of the shell.
Tilt the back panel up and pull it away from the top edge of the shell to release it from the gap.
Remove the back panel.